Enter the PIN to be used as your User code and press.Press and hold + 1 until the BLUE LED glows solidly and the GREEN LED starts blinking.Enter the Admin Mode by pressing and holding + 0 for five seconds (RED LED will blink.)Įnter the Admin PIN and press (BLUE LED will glow solidly.).Since the Secure Key ships with a partial charge, plug it into a powered USB port for 60-80 minutes to give the battery a full charge before initial setup (RED LED will still be blinking.) After initial Admin PIN setup, when plugged into a powered USB port while in standby mode, the Red LED will pulse to indicate that it’s charging and will glow solidly once fully charged. The Aegis Secure Key has an internal rechargeable battery with a smart charging circuit and will automatically charge whenever it’s plugged into a powered USB port. If no additional users are to be added or Admin features set, Secure Key setup is now complete and ready for use.ĭo NOT press any buttons while the Secure Key is plugged into a USB port. Doing so may cause damage to the USB port and Secure Key USB Connector.

To exit the Admin mode, press (RED LED will glow solidly) or wait 30 seconds and Secure Key will return to sleep mode.Quickly re-enter that same PIN once more and press (BLUE LED will turn off momentarily and GREEN LED will illuminate for one second until replaced by the BLUE LED glowing solidly, indicating that the Admin PIN has been set and the Secure Key is in Admin mode, ready to add another User PIN or for setting up features.).Enter the PIN to be used as your Admin code and press (If PIN is accepted, BLUE LED will turn off momentarily and GREEN LED will blink 3 times by itself, then will continue blinking as the BLUE LED glows solidly.)*.(BLUE LED will glow solidly and GREEN LED will blink.) (BLUE and GREEN LEDs will glow solidly, indicating no Admin PIN has been established.)

Apricorn usb drive